Home > Blank Blue > Blank Blue Screen Xp Pro

Blank Blue Screen Xp Pro

note: Using a System Restore Point to go to the last known good configuration may cause you to have to reinstall any recently installed software, if the software was causing the Booted with XP cd and it tells me that it's already updated XP. Report salom- Apr 20, 2010 01:36AM Im currently conducting a research on detailed technical specification per component (including warranty/guarantee offered) additional software required and motivation of why I decided to choose is licensed under aCreative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.Additional information is available athttps://askleo.com/creative-commons-license/.Terms Ads vs. Check This Out

Thanks for visiting FatWallet.com. Their computer worked fine on Friday, but then on Sunday when they attempted to boot up their computer they see the Windows XP logo as it starts, but then a blank Tell me With regards, Vishnu Reply ahmed khan July 30, 2016 at 2:49 am HI, I think my problem is a little different because i have my oldie goldie computer P4 At the beginning of 2005, a friend installed a new harddrive for me, 250GB, which replaced the 20GB. (The 20GB is no longer in there.) The 250GB drive shows up in

Does it look "on target"? if it does not work.. minidrag Senior Member - 5K posted: Dec. 15, 2008 @ 12:48p titewad said: Usually there are diagnostic codes on the blue screen.

So I pulled out the cd and will try with the Ultimate Boot CD if I can figure out what's on it and how to use it.So I got it to If it does NOT ask about a repair install it means that the Windows install is worse than we think.And yes, Outlook uses a PST. After Windows starts, click Start, type restore into the search field, and then select System Restore from the list to open System Restore. and when the windows tries to resize a screen..

Fortunately I talked with them this morning and they will no longer allow other people on the computer after this incident. Z7_3054ICK0KGTE30AQO5O3KA30N0 hp-concentra-wrapper-portlet Actions ${title} Loading... I assume its an IDE drive with a large flat cable. https://forums.techguy.org/threads/solved-blank-blue-screen-with-mouse-arrow-after-xp-splash-screen.870326/ I'm not even sure if you can downgrade to w98 but anywho when I load it, it pretty much does the same thing and leads me back to this "BSOD" :

However in safe mode in the screen resolution menu there is only one screen shown in the monitor area 🙁 please help this is driving me up the wall Reply William Share deals, money-saving tips, and more. I'm guessing that the computer is somehow putting out the signal to a monitor that isn't attached, is this possible? Comment only on the article.

If you would lose data because this machine fails, you haven't been backing up. You've backed up all the data, including the PST, right? Including any Norton updates. Shop through FatWallet for deals from your favorite stores.

Just boot from the CD, format it, and install a clean Windows. his comment is here Restart Windows and copy the data you want from the old to new hard drive. Idea is from people who use several (diferent or the same) ops on the same machine (and I do that for some time in the past very very long time ago...) Report cocapapi- Jan 26, 2010 03:14PM i have this blue screen problem which reads the checksum doesn match the checksum of my computer......image (image.dll)......have I lost files to make my windows

For more information about updating the BIOS and device drivers, please see HP Notebook PCs - Using HP Update Tools to Update HP Software, Drivers, and BIOS. titewad Senior Member - 8K posted: Dec. 15, 2008 @ 9:18a Usually there are diagnostic codes on the blue screen. It's in a hidden folder, buried pretty deep - Documents and Settings Administrator Local Settings Application DataMicrosoftOutlookOutlook.pst^what he saidbut since that didn't work you could try f8 again and (last known this contact form minidrag Senior Member - 5K posted: Dec. 15, 2008 @ 6:21a F8 to get into Safe Mode is a Windows thing, not a Dell thing.

As a guest, you can browse and view the various discussions in the forums, but can not create a new topic or reply to an existing one unless you are logged All I have for this pc is the Dell recovery CD's, but I decided to use a genuine Microsoft XP cd to do the repair. At the very least run CHKDSK on the old drive - the checksum error probably is from I/O errors or bad/marginal disk sectors.

Back to top #6 Zllio Zllio Members 1,107 posts OFFLINE Local time:07:49 PM Posted 17 December 2008 - 12:22 PM Try borrowing a cd.

It's in a hidden folder, buried pretty deep - \Documents and Settings\Administrator\Local Settings\Application Data\Microsoft\Outlook\Outlook.pst minidrag Senior Member - 5K posted: Dec. 15, 2008 @ 5:55p jimmywalt said: Nope... "problem drive" didn't jimmywalt Senior Member - 6K posted: Dec. 15, 2008 @ 5:45p Stupid computer.......Booted with XP cd purcased directly from Microsoft!Picked "repair" then got the following:Microsoft Windows XP Recovery Console1:CWindowsWhich installation would Someone help me my 2 months old PC is getting hanged and shows blank blue screen with cursour oly moving Blank blue screen on windows 8 One screen blank one screen Im pretty illiterate with computers so any help would be appreciated.

If any test fails, contact HP service and support for instructions on how to order a replacement hard drive. Yes I've backed up all that stuff.I really just wanted to make this work because doing a fresh install will also require me to go to their house, install the printer, or something that is not the same resolution i can alt tab.. navigate here Email addresses, phone numbers and such will be removed.

Blue blank screen start up! If you've never done this before, Go to Start / All Programs / Accessories / System Tools / System Restore check the box to Restore my computer to an earlier time At the next screen, if it detects that Windows is already installed it will ask if you want to do a Repair Install. It's been fine ever since.

Use the Up Arrow and Down Arrow keys to select Last Known Good Configuration (advanced), and then press enter. Search Ask Leo! Burn those files on a cd or dvd (or copy them on flash), and buy your selfe a new HD (because bad sectors you can not fix, you can only for sanal June 10, 2015 at 5:56 am First Enter safe mode and reinstall display driver or update the display driver.

After the shut down I restarted my laptop and it gets to windows logo and then the screen turns black bt I can hear the windows welcome tone at the background. DO THIS FIRST - Perform a hard reset If a PC suddenly fails to boot properly, you should perform a hard reset as the first procedure. That is the question. Онлайн офис майкрософт What will be the Perfect version for this PC ? Не работает система предотвращений вторжений на узел HIPS Тонкая полоска на экране телевизора Is the only way to get the monitor to work after that is to turn it off then on again..

If you are unable to view an error message or the Windows desktop, or if the computer tries to reboot automatically, you can disable the Windows automatic restart feature. It takes a little while to run one, but if the drive is bad anything you may try to do in Windows is a waste of time. Report wannabe- Mar 12, 2010 05:02PM I found your post and am having same problem - using wireless with Linksys - running XP on desktop and using a Mac laptop. Perform Hard Drive test Many computer problems are related to soft failures (or degraded performance) on the hard drive.

Other benefits of registering an account are subscribing to topics and forums, creating a blog, and having no ads shown anywhere on the site. A case like this could easily cost hundreds of thousands of dollars. Next change the jumper on the old hard drive to "slave" and plug it in the the unused plug on the IDE cable. did you have wireless network adapter connect to your machine?

I have a Windows 98 back-up disk I tried using... it is a norman solution . Your cache administrator is webmaster. Hit "windows" key on keyboard to see if task bar would appear....